Euromicron Mould Engineering Limited was found in 1995

Euromicron Mould  >  AI - Page Sitemap  >  Euromicron Mould injection electronic housing wholesale for andon electronics
Euromicron Mould injection electronic housing wholesale for andon electronics

Euromicron Mould injection electronic housing wholesale for andon electronics
  • Euromicron Mould injection electronic housing wholesale for andon electronics
  • Euromicron Mould injection electronic housing wholesale for andon electronics
  • Euromicron Mould injection electronic housing wholesale for andon electronics

Euromicron Mould injection electronic housing wholesale for andon electronics

Part Name...
Inquire Online
Get the latest price
Quantity Needed:
Pieces
E-mail:


Part Name:Gateway
Part size:175*136*32mm
Raw Material:ABS+PC
Color:RAL9010,White
Mould Cavity No.:1*1
Injection gate:Hot runner with pin point gate
Surface finished: Mirror Polishing
Core &Cavity steel:1.2344,hardness 48~52HRC
Mold component standard:HASCO or equivalent
Injection machine size:180T
Cycle time:35S
Mold life:300000 shots
Customer:HEKATR@N
Export:Germany


◇◆ Summary for project running
This product used for electrical appliance,the gateway case and grid.Plastic raw material need in inflaming retarding and heat resistant.
Euromicron Mould injection electronic housing wholesale for andon electronics-1

We carried out first trial shot on 40th day,little longer than planed.Since YUDO hot runner system came out of expected date,one week late.Three trial shots for samples production,and finished whole project in 50days.Manufacture schedule,samples delivery and mold shipment date ran as planing,within customer’s request.
Both parts critical surface need in high polishing,mirror grade,no any marked or scratch allowed.When production,have to take out by robot hand,and cover PE film for protection. Silkscreen also made by EMM factory.

Euromicron Mould injection electronic housing wholesale for andon electronics-2

At first trial shot,case part came out with obvious sink mark and scratch on side surface. The ribs inside are too thick cause sink mark,and no draft angle on side surface cause scratch when mold open.Finally We cut rib material solved sink mark problem.But no draft angle allowed on side surface,we had to add two sliders on both side,to ensure all outside surface look glossy.
The grid part has many small window and only 0.6mm thick.We found flowing mark at each window corner and short shot problem at first trial shot.Then we suggested change high polishing surface to fine texture,VDI3400-33,also change injection gate location,from both side for filling.Customer confirmed and part came out look good.




Euromicron Mould electronic housing is manufactured by making use of their understanding of market knowledge. It is the most optimal equipment for all sizes of biscuit food factories
Euromicron Mould electronic housing is fabricated employing optimal-grade raw material and with the aid of highly advanced machines. Featuring a good lubricating effect, this product will be not easy to fail
electronic housing is made from eco-friendly materials to minimize pollution and use of resources in materials and production and disposal. Its conveying belt can be customized according to needs
With its appealing design, Euromicron Mould plastic enclosures for electronics will attract more attention than before. The components or parts of this product can be easily replaced
Euromicron Mould plastic enclosures for electronics is produced in a highly standardized production environment. This product is characterized by its high production efficiency
This product is ideal for quick opening and closing of lights because it is able to provide full light immediately. The components or parts of this product can be easily replaced
Product Message
Chat Online 编辑模式下无法使用
Chat Online inputting...