loading

Euromicron Mould Engineering Limited was found in 1995

Euromicron Mould  >  AI - Page Sitemap  >  Euromicron Mould corporation electrical molding supplier for andon electronics
Euromicron Mould corporation electrical molding supplier for andon electronics

Euromicron Mould corporation electrical molding supplier for andon electronics
  • Euromicron Mould corporation electrical molding supplier for andon electronics
  • Euromicron Mould corporation electrical molding supplier for andon electronics
  • Euromicron Mould corporation electrical molding supplier for andon electronics

Euromicron Mould corporation electrical molding supplier for andon electronics

electrical molding tend to be injection molded electronics than other brands. It doesn't have the problem of easy brittleness at a very low temperature
Inquire Online
Get the latest price
Quantity Needed:
Pieces
E-mail:


Part Name:Gateway
Part size:175*136*32mm
Raw Material:ABS+PC
Color:RAL9010,White
Mould Cavity No.:1*1
Injection gate:Hot runner with pin point gate
Surface finished: Mirror Polishing
Core &Cavity steel:1.2344,hardness 48~52HRC
Mold component standard:HASCO or equivalent
Injection machine size:180T
Cycle time:35S
Mold life:300000 shots
Customer:HEKATR@N
Export:Germany


◇◆ Summary for project running
This product used for electrical appliance,the gateway case and grid.Plastic raw material need in inflaming retarding and heat resistant.
Euromicron Mould corporation electrical molding supplier for andon electronics-1

We carried out first trial shot on 40th day,little longer than planed.Since YUDO hot runner system came out of expected date,one week late.Three trial shots for samples production,and finished whole project in 50days.Manufacture schedule,samples delivery and mold shipment date ran as planing,within customer’s request.
Both parts critical surface need in high polishing,mirror grade,no any marked or scratch allowed.When production,have to take out by robot hand,and cover PE film for protection. Silkscreen also made by EMM factory.

Euromicron Mould corporation electrical molding supplier for andon electronics-2

At first trial shot,case part came out with obvious sink mark and scratch on side surface. The ribs inside are too thick cause sink mark,and no draft angle on side surface cause scratch when mold open.Finally We cut rib material solved sink mark problem.But no draft angle allowed on side surface,we had to add two sliders on both side,to ensure all outside surface look glossy.
The grid part has many small window and only 0.6mm thick.We found flowing mark at each window corner and short shot problem at first trial shot.Then we suggested change high polishing surface to fine texture,VDI3400-33,also change injection gate location,from both side for filling.Customer confirmed and part came out look good.




The production of injection molded electronics always takes injection molded electronics into account. It doesn't shrink at low temperatures or high temperatures easily
Our injection molded electronics are constantly updated to follow the trend. The product has an improved tensile strength
electrical molding produced by Euromicron Mould Engineering Limited are mainly characterized by their electrical molding. The product features easy soakage by bitumen
The material of injection molded electronics allows injection molded electronics to make itself injection molded electronics. It is mainly used for electronics, chemicals, aerospace, automobile, and other industries
The special composition of injection molded electronics makes it obtain good performance of electrical molding. Being resistant to harsh environments, it can be used both indoors and outdoors
Our electrical molding not only has excellent quality, but also has an affordable price, and the overall cost performance is relatively high.
Product Message
Chat Online 编辑模式下无法使用
Leave Your Message inputting...