Electronic Parts, Electronic Connector Product By Precision Injection Molding

Product Information
Customer Reviews

Application Scope

die casting mold has a wide range of applications.Euromicron insists on providing customers with reasonable solutions according to their actual needs.Euromicron's cnc service are made of high-quality raw materials. They have the advantages of wear resistance, rust resistance, pressure resistance and good durability. Besides, they are not easy to damage and aging.

Company Advantages
1. The production of Euromicron Mould precision molded plastics adopts internationally recognized standards. It keeps its appearance as bright and clean as a new one after long-term use
2. It has been rigorously tested for quality and performance. Its appearance is stylish and creates a stereoscopic sense
3. electronic parts are more likely to attract customers or to make repeat purchases. It is manufactured to have stable chemical properties

This connector was supposed to be molded in glass-fiber-reinforced,flame-retardant nylon.

It came with size 35X29.5X26mm,with 40pcs pins in center.High rib,hooks and boss on round side.One four cavity mold should employ a mold base dimension 250*230mm,with 280mm height.Steel grade 1.2767 is used for the mold inserts,while grade 1.2312 is employed for mold plates as well as the ejector plate.Steel grade 1.1730 is mused for remaining plate and rails.Thermal insulating plates,which are available in sizes to match the standard mold plates,serve to insulate the mold from the machine platens.

◇◆ Mold design

This part is simple,but need to ensure 40pcs pin locate properly when plastic filling,specially under high pressure flow.To save production cost,we need to cut down cycle time.So two or three even more over-mold inserts need.Injection machine operator no need to set pin one by one into mold.Just need to set in additional insert before molding.When mold open,just need put whole insert with pin into core.Of course,operator need to take part with insert together.The hooks on both sides are undercut,need design for slider or angle lifter.But no slider split line allow in middle surface.So split line should be set on radius of corner.

The molded part is ejected via knockout pins.In addition to providing for ejection.these pins serve to vent the cavity during filling.It is in part for this reason that the knockout pins are located beneath ribs and other deep section of the part.where entrapped air is to be expected.The mold filling pattern during injection of the molding compound as well as the mechanical and thermal aspects of the mold design were simulated and established during the design phase with the aid of appropriate computer programs.

Company Features
1. Euromicron Mould series is very popular amongst the users both in China and abroad.
2. Euromicron Mould Engineering Limited is often referred as Euromicron Mould, taking over its place in electronic parts market.
3. Euromicron Mould aims to build the first national brand! Inquire online!

Favorable rate

100%

Buyer impression